winchester small pistol magnum primers Options
winchester small pistol magnum primers Options
Blog Article
I just checked out my IMR data booklet. Indeed, you are able to, However they provides you with about 1245 fps and 11200 psi. If you need a load much more like what you have been loading with the WWs again off a few half a grain, usually, Indeed, You should utilize them With this application. But you are receiving the exact general performance while you might have been having with 19 gr and WW primers.
What The shopper gets is not similar to was what examined several years back considering the fact that There's a also a large "environmental" unfamiliar. Wherever the powders been, how it absolutely was stored, wherever it had been saved, and at what temperature, and for how much time.
"A properly controlled Militia, getting important to the safety of a totally free State, the appropriate on the people to maintain and bear Arms, shall not be infringed"
I have loaded Cheddites for much more than a yr now Because the price and availability for Winchester and Remington's has become scarce.
But no genuine trouble because With all the hull. Now... my rammer tube shifting is an additional difficulty. I've some AA's and Fiocchi's also inside the rotation. It might get a while at my shooting rate before I use out the hulls and possess to interrupt in a new set of primer pockets.
about to Cheddites. I will never invest in A further Winchester once they left us reloaders out to dry. There
What I did do was point out that the Cheddite primer is actually a much closer match to the Federal 209A primer which nobody would propose for a substitute for your Winchester 209 primer in ALL recipes.
The only real information I give on which you happen to be entitled to depend is that which I'm capable to offer and for which you've compensated me. Follow all other tips at your individual danger.
I have had exactly the same difficulty that you simply experienced and did the exact same reducing from the powder/ primary tube. Or else you should not have an issue with cheddites; but some shotguns may pierce cheddites occasional or routinely which typically causes firing pin erosion.
This is certainly an older thread, you may not get a reaction, and could be reviving an aged thread. You should look at making a new thread.
Once more, my commendation to templetk-- many good indicators including the simple fact he analyzed ten rounds so his data can create good SD success; and his SDs ended up pretty tight, indicating to me that he in truth probably was extremely diligent in his loading procedures.
The only advice I give on which that you are entitled to depend is that which I'm qualified to provide and for which you might have paid me. Abide by all other tips at your very own threat.
They appear to be near the Winchester W209, so in case you started out 209 primers for sale out with this type of load and modified it (dropped 1/2 grain) like I explained previously, you would in all probability be OK. When in doubt, contact the powder organization and find out the things they suggest. You could usually address it as the most well liked primer stated and act accordingly.
Although that rule could keep true for many Europeon primers, my dial calipers display the Cheddite cylinder to become a little bit considerably less. The Cheddites evaluate out @ .243 as well as W209 @ .244 on common when checked. Cheddites undoubtedly are a a lot less high priced alternative for the W209 for me.